GAF-PiHat INSTALLATION MANUAL
Welcome to the PoE Texas Manual for the GAF-PiHat!
The purpose of the manual is to help you quickly and effectively navigate the installation and functions of your new Power Over Ethernet Adapter.
Our goal is to make our products as intuitive and simple to use as possible, so we value your feedback and questions directly to us at service@poetexas.com. Phone +1-512-479-0317.
Or you’re always welcome to leave questions or comments on our product pages: GAF-PiHat.
What’s Inside
PARTS LIST: GAF-PiHat
- 1 X PoE Adapter for Raspberry Pi 3B+ and 4
- 1x Heat guard
No, unfortunately, this doesn’t come with a case, however it fits most new cases including the official one.
General Installation
Your new PoE hat is designed to be simple to install and set up. Simply orient the correct pins on the Pi, then press it down fully.
And that’s it. Once it is in place, simply plug the RJ-45 end into an IEEE 802.3af PoE or 48-56 volt passive Power Sourcing Equipment (PSE) with a data source, and the Pi will start to power up automatically.
Please note that the PiHat is rated for 12.9 watts. If you plan to load down the process or and plug devices into all the USB ports, you might find you draw closer to 15 watts. For that, we recommend our GAT-5v20w with a microUSB connector.
CONFIGURATION
There is no configuration necessary with this device. Simply plug it in and follow the installation instructions.
Technical Specifications
Product Specifications
Product Specifications
| Certifications | CE, FCC, RoHS |
| Connector Types | Two 4 pin x 1 mm |
| Data Rate | 10/100/1000 |
| Dimensions | 2 5/8″ x 1 1/2″ x 7/10″ |
| Efficiency | 90% |
| Max Current | 2500 mA |
| Mount Type | Board Mounted |
| Operating Humidity | 10-90% non condensing |
| Operating Temperature Range | 0 – 40C |
| Output Voltage | 5 volt |
| PoE Mode/Pinout | Mode A/Mode B |
| PoE Standard | IEEE 802.3af (Passive 48 VDC) |
| Weight | 1 oz |