Home » Technical Center » AF-USBC

AF-USBC – IEEE 802.3af PoE to USB-C Splitter

PoE to USB-C

What’s Inside



The AF-USBC comes with a male USB-C connector and an RJ-45 Connector.

General Installation

Your new PoE splitter is designed to be simple to install and set up.  It is small and light enough to leave “inline” with your network cable.

A adhesive or screw backed cable anchor is sufficient to hang the adapter on a wall or enclosure.

Once it is in place, simply plug the end of your category cable into an IEEE 802.3af PoE or 48-56 volt passive Power Sourcing Equipment (PSE) with a data source (optional), and the other end into your device such as a camera, Raspberry Pi, Android tablet, or any compatible device.

Please note that this device does not operate on the Power Delivery PD standard.  That means, for example, iPads, Nest Cameras, Samsung Tablets, etc will not necessarily negotiate power and charge.  Please test your device prior to use.  If you do need Power Delivery (PD) charging, you can see our full line of PD compatible devices:

I Want Power and/or Data for my iPad Air, Samsung Tab, or a Power Delivery Device!

Visit Our Full Line of Power Delivery Compatible Devices


There is no configuration necessary with this device.  Simply plug it in.


The yellow LED indicates power on the primary side (your PoE side).  The green indicates power on the secondary (5 volt side).

Technical Specifications

Product Specifications

Cable connector length 8.5 inches
Cable connectors RJ45 Male, USB-C Male
Data + PoE Ports 1 (input)
Data Ports 1
Data Rate 10/100 Mbps
Connector USB-C Male
Dimensions 6x1x1.5 in.
Input voltage 44 volts to 57 volts
Max. Amps Per Port 2
Operating Humidity 5% to 90%
Operating Temperature Range -10 to 60°C
Output Voltage 5 volts (no Power Delivery)
PoE Method Active
PoE Mode/Pinout Mode A (-1,2 +3,6)/Mode B (+4,5 -7,8)
Power Input Female RJ45
Weight 1 oz

If you find this learning center helpful, like and subscribe on your social channels to learn when we post new guides!