IGOR Rev 5.0; 60 Watt Network and Device Node Controllers
Igor Network and Device Nodes provide the data connectivity and power distribution architecture to create a fully functioning PoE lighting control system. The Igor Gateway software communicates bi-directionally with the nodes to control lighting for each space, as well as to receive signals from sensors and other devices to improve occupant comfort and optimize energy savings.
Network Nodes: Network Nodes act as an intelligent hub for the PoE lighting network. They receive power and data from the PoE network switch, interact with connected devices and pass power and data downstream to any daisy chained Device Nodes via the Igor Bus. As LED fixtures and sensors are connected and configured, the node will automatically report those devices back to the Igor Gateway software for easy plug and play functionality. Each Network Node is also DHCP-enabled and will automatically receive an IP address from the local network to simplify installation and setup.
Device Nodes: Device Nodes extend the functionality and reach of the Igor solution. They allow multiple nodes to be linked together in a daisy chain from each Network Node via typical Ethernet patch cables. Additional LED fixtures and sensors can be connected without the need for multiple cable runs back to the data closet. This results in optimal power utilization and reduces the overall installed system cost by using fewer switch ports and network switches.
Node Levels: Three Node level options allow you to build your intelligent lighting system to spec. With Min, Mid and Max variations, you can support up to a maximum of 32 devices per 1 network homerun when daisy chaining 5 nodes together. All network devices are individually addressable and programmable with IGOR software
|Connector Types||RJ45 x 2; Screw Terminals / Varies per Node Level - MIN, MID, MAX|
|DC Power Input||60 Watts|
|Dimensions||4.54 x 2.87 x 1.1 in|
|Input Voltage Range||48-57VDC|
|IP Rating||IP20 for Indoor Use Only|
|Max Power for Kit||53 Watts Max|
|Mount Type||Wall Mount|
|Operating Humidity||10% to 80% RH non-condensing|
|Operating Temperature Range||0 to 70 C|
|PoE Standard||IEEE 802.3bt / PoE++|
|Power Input||PoE - Device Nodes Powered via Daisy Chain Only Using Network Node|
|Storage Temperature||-20 to 85 C|